Quick Answer
When working with tarred bankline, expert tips include using a sharp knife to minimize tar splatters, and carefully heating the tar to maintain its adhesive properties before and during use. This requires attention to temperature control and handling.
Controlling Tar Splatters
When working with tarred bankline, the first step is to minimize tar splatters. To do this, use a sharp knife with a straight edge to cut the bankline. A dull knife will cause the tar to splatter and make a mess. Hold the knife at a 45-degree angle and cut the bankline in a smooth, steady motion. This will help to minimize the amount of tar that is released as you cut.
Heating and Handling Tar
To maintain the adhesive properties of the tar, it’s essential to heat it correctly. Apply heat to the tar using a low-wattage heat source, such as a hair dryer or a heat gun. Once the tar is warm, it will be more pliable and easier to work with. Use a gloved hand to handle the tarred bankline, as the tar can be hot and sticky. Apply a thin layer of tar to the bankline using a brush or a cloth, and then wrap the bankline around the object you’re securing.
Securing the Bankline
To secure the tarred bankline, use a series of knots or twists. Begin by wrapping the bankline around the object 2-3 times, overlapping the coils as you go. Then, tie a series of square knots or twists to secure the bankline in place. Use a sharp knife to trim any excess bankline, and apply a small amount of tar to the ends to seal them. This will help to prevent the bankline from coming loose over time.
Find more answers
Browse the full Q&A library by topic, or jump back to the topic this question belongs to.